Memorex LOCK - VERSION 2-24 Informations techniques télécharger pdf (Page 409)

100

101

SET Control Statement

User Reference

Use Pursuant to Company Instructions

10-15

// EXEC TSIDFAV

VSE JCL

// JOB TSIDFAV

* DISK INPUT

// DLBL DISKIN,'FAV.INPUT.JCL' REQUIRED

// ASSGN SYS004,DISK,...

// UPSI XXXX0

// EXEC TSIDFAV

POWER Mode When using POWER mode, the job control must be submitted backwards,

in reverse order of execution, and upside down so that card column 1 is

submitted to TSIDFAV in card column 80. This prevents POWER from

processing any POWER JECL submitted as instream data. The JCL can

be submitted either as instream data, following the EXEC statement, or

via tape or disk input using the DTF name DISKIN. If the input is

submitted after the EXEC statement, SYS004 must be assigned to

SYSIPT.

The EOF flag must be submitted in columns 1 and 2, not reversed.

Note:Note:

This technique can be used only in installations that still have physical

card readers.

JCL Examples

for POWER

Mode

The following are JCL examples when using POWER mode.

// JOB TSIDFAV

* INPUT INSTREAM DATA

// ASSGN SYS004,SYSIPT REQUIRED

// UPSI XXXX1

// EXEC TSIDFAV

VSE JCL AND POWER JECL READ WITH 9 EDGE IN

-- (EOF FLAG)

// JOB TSIDFAV

* DISK INPUT

// DLBL DISKIN,'FAV.INPUT.JCL' REQUIRED

// ASSGN SYS004,DISK,...

// UPSI XXXX1

// EXEC TSIDFAV

TSIDFAV reads the VSE procedures and POWER SLIs from the

appropriate VSE library. However, TSIDFAV does not support either

PROC or SLI overwrites. Nested SLIs are supported. However, nested

PROCs are not supported.

1 2 ... 404 405 406 407 408 409 410 411 412 413 414 ... 567 568

Commentaires sur ces manuels

Pas de commentaire

Memorex LOCK - VERSION 2-24 Informations techniques Page 409

Commentaires sur ces manuels